Our Customer Support Center provides a 24-hour service. IEEE Std C37.90 (see Chapter 4, Technical Data")Īdditional Support Should further information on the System SIPROTEC 4 be desired or should particular problems arise which are not covered sufficiently for the purchaser's purpose, the matter should be referred to the local Siemens representative.
The product conforms with the international standard of the series IEC 60255 and the German standard VDE 0435. The device has been designed and produced for industrial use. This conformity is proved by tests conducted by Siemens AG in accordance with the Council Directives in agreement with the generic standards EN6 and EN 6 for the EMC directive, and with the standard EN 60255-27 for the low-voltage directive. Indication of Conformity This product complies with the directive of the Council of the European Communities on the approximation of the laws of the Member States relating to electromagnetic compatibility (EMC Council Directive 2004/108/EC) and concerning electrical equipment for use within specified voltage limits (Low-voltage directive 2006/95 EC).
Applicability of this Manual This manual applies to: SIPROTEC 4 Multifunctional Machine Protection 7UM62 firmware version V4.7. Target Audience Protection engineers, commissioning engineers, personnel concerned with adjustment, checking, and service of selective protection equipment, automatic and control facilities, and personnel of electrical facilities and power plants.
General information with regard to design, configuration, and operation of SIPROTEC 4 devices are set out in the SIPROTEC 4 System Description /1/. As well as a compilation of the most significant data for advanced users → Appendix A.Compilation of the Technical Data → Chapter 4.Instructions for Installation and Commissioning → Chapter 3.Information regarding the configuration of the scope of the device and a description of the device functions and settings → Chapter 2.Preface Purpose of this Manual This manual describes the functions, operation, installation, and commissioning of devices 7UM62. Other designations in this manual might be trademarks whose use by third parties for their own purposes would infringe the rights of the owner. Registered Trademarks SIPROTEC, SINAUT, SICAM and DIGSI are registered trademarks of Siemens AG. All rights reserved, particularly for the purposes of patent application or trademark registration. Document Version 4.70.02 Release date 09.2013ĭissemination or reproduction of this document, or evaluation and communication of its contents, is not authorized except where expressly permitted. We reserve the right to make technical improvements without notice. We appreciate any suggestions for improvement. The information given in this document is reviewed regularly and any necessary corrections will be included in subsequent editions. However, deviations from the description cannot be completely ruled out, so that no liability can be accepted for any errors or omissions contained in the information given.Ĭopyright © Siemens AG 2013.
We have checked the text of this manual against the hardware and software described. Note For safety purposes, please note instructions and warnings in the Preface. Mounting and Commissioning Technical Data Appendix